Accessing The Hood; Lubrication; Greasing The Machine - Toro Workman MDX-D Operator's Manual

Hide thumbs Also See for Workman MDX-D:
Table of Contents

Advertisement

Accessing the Hood

Raising the Hood
1.
Lift up the handle of the rubber latches at each
side of the hood
Figure 25
2.
Raise the hood.
Closing the Hood
1.
Gently lower the hood onto the chassis.
2.
Secure the hood by aligning the rubber latches
onto the latch anchors at each side of the hood
(Figure
25).
(Figure
25).

Lubrication

Greasing the Machine

Service Interval: Every 100 hours/Yearly (whichever
Grease Type: No. 2 lithium grease
1.
Use a rag to wipe the grease fitting clean so that
foreign matter cannot be forced into the bearing
or bushing.
2.
With a grease gun, apply 1 or 2 pumps of grease
into the grease fittings on the machine.
3.
Wipe the excess grease off the machine.
The grease fittings are located at the inner end of the
control arms
(Figure
outer end of the control arms
g008402
30
comes first)—Grease the bearings
and bushings. Grease the machine
more frequently when using it for
heavy-duty operations.
26), the tie-rod ball joint, and the
(Figure
27).
Figure 26
Left Side Shown
Figure 27
Left Side Shown
g033044
g033217

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

0723607236tcWorkman mdx-d series

Table of Contents