Changing The Transaxle Fluid; Checking And Adjusting Neutral - Toro Workman MDX-D Operator's Manual

Hide thumbs Also See for Workman MDX-D:
Table of Contents

Advertisement

Changing the Transaxle
Fluid
Service Interval: Every 800 hours/Yearly (whichever
comes first)
Fluid Type: SAE 10W-30 (API service SJ or higher)
Fluid Capacity: 1.4 L (1.5 US qt)
1.
Park the machine on a level surface, shut off the
engine, engage the parking brake, and remove
the key from the key switch.
2.
Wipe the area around the fill and drain plugs
clean with a rag
(Figure
Figure 50
1. Drain plug
3.
Align a drain pan with a capacity of 2 L (2.1 qt)
or more under the drain plug.
4.
Remove the fill plug by rotating it
counterclockwise
Note:
Retain the fill plug and gasket for
installation in step 8.
5.
Remove the drain plug by rotating it
counterclockwise
Note:
Retain the drain plug and gasket for
installation in step 6.
Note:
Allow the oil to drain from the transaxle
completely.
6.
Install and tighten the drain plug and gasket into
the drain-plug hole of the transmission
50).
Note:
Dispose of the used fluid at a certified
recycling center.
7.
Fill the reservoir
hole with approximately 1.4 L (1.5 US qt) of
the specified fluid or until the fluid level in the
transmission is even with the bottom of the
threads.
(Figure
50).
2. Fill plug
(Figure
50).
(Figure
50).
(Figure
51) through the fill-plug
50).
1. Fluid fill
8.
Install and tighten the fill plug and gasket into
the fill-plug hole of the transmission
9.
Start the engine and operate the machine.
10.
Check the fluid level and add more fluid if the
level is below the threads of the fill-plug hole
(Figure
Checking and Adjusting
Neutral
g002109
Service Interval: Every 100 hours
When performing routine maintenance and/or engine
diagnostics, you must shift into N
The machine has a N
lever, which controls the neutral in the transaxle. The
following steps should be taken to make sure that
the neutral shift lever operates the transaxle neutral
correctly:
1.
Set the shift lever into the N
2.
Ensure that the neutral bracket is in the N
position (level to the cable mounting bracket
located below the shift bracket) by turning the
driven clutch
Note:
forth. If it does, manually move the neutral
bracket to the N
(Figure
44
Figure 51
50).
EUTRAL
position on the shift
EUTRAL
EUTRAL
(Figure
52).
The machine should not roll back and
position.
EUTRAL
g004048
(Figure
50).
(Figure
52).
position.
EUTRAL

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

0723607236tcWorkman mdx-d series

Table of Contents