Adjusting The Brake Cables; Changing The Brake Fluid - Toro Workman MDX-D Operator's Manual

required to set the parking-brake lever, perform
the procedure for adjusting the brake cables;
refer to Adjusting the Brake Cables (page
4. Tighten the set screw and install the hand grip
(Figure 56).

Adjusting the Brake Cables

1. Remove the hand grip from the parking brake
(Figure 56).
2. Loosen the set screw
brake-adjustment knob to the parking-brake
lever, disengage the parking brake, and loosen
the brake-adjustment knob.
3. At the bottom of the machine, loosen the
rear-jam nut for the threaded adjuster of the
parking-brake cable 4 turns
1. Forward-jam nut
2. Rear-jam nut
3. Brake-cable bracket
4. Tighten the forward jam nut
5. Rotate the brake-adjustment knob
until a force of 133 to 156 N∙m (30 to 35 ft-lb) is
required to engage the parking-brake lever.
•
If you cannot adjust the brake-adjustment
knob by loosening it and set the
parking-brake lever with a a force of 133
to 156 N∙m (30 to 35 ft-lb); perform the
following:
A. Loosen the forward-jam nut
57) for the threaded adjuster of the
parking-brake cable 1 turn.
B. Tighten the rear jam nut
C. Rotate the brake-adjustment knob
(Figure 56) until a force of 133 to
156 N∙m (30 to 35 ft-lb) is required to
engage the parking-brake lever.
D. Repeat steps
times to attain the parking brake force
between 133 to 156 N∙m (30 to 35 ft-lb).
(Figure 56) securing the
(Figure 57).
Figure 57
4. Threaded adjuster
(parking-brake cable)
5. Front of the machine
(Figure 57).
(Figure
(Figure
(Figure
A through C up to 2 more
•
If you cannot adjust the brake-adjustment
knob by tightening it and engage the
48). parking-brake lever with a a force of 133
to 156 N∙m (30 to 35 ft-lb); perform the
following:
A.
B.
C.
D.
Note:
cable enough to get the brake-adjustment
knob within its adjustment range, check the
brake pads for excessive wear.
•
Tighten the set screw and install the hand
grip

Changing the Brake Fluid

g029672 Service Interval: Every 1,000 hours
Refer to your authorized Authorized Service Dealer.
56)
57).
48
Loosen the rear-jam nut
57) for the threaded adjuster of the
parking-brake cable 1 turn.
Tighten the forward jam nut
Rotate the brake-adjustment knob
(Figure 56) until a force of 133 to
156 N∙m (30 to 35 ft-lb) is required to
engage the parking-brake lever.
Repeat steps A through
times to attain the parking brake force
between 133 to 156 N∙m (30 to 35 ft-lb).
If you cannot adjust the parking-brake
(Figure 56).
(Figure
(Figure 57).
C up to 3 more