Toro Workman MDX-D Operator's Manual page 15

Gear-Shift Selector
The gear-shift selector is located between the seats
and below the parking-brake lever. The gear-shift
selector has 3 positions: F
N (Figure 6).
EUTRAL
Note:
The engine starts and runs in any of the 3
positions.
Important:
Always stop the machine before
changing gears.
Horn Button
Model 07236TC Only
The horn button is located at the lower, left corner of
the dash panel (Figure
sound the horn.
1. Horn button (Model
07236TC)
2. Hour meter
3. Light switch
4. Battery light
5. Engine oil-pressure light
Light Switch
The light switch is located to the left of the steering
column (Figure 8). Use the light switch to illuminate
the headlights. Push up the light switch turn on the
headlights or push down the switch to turn off the
lights.
Hour Meter
The hour meter is located to the left of the light switch
(Figure 8). Use the hour meter to find out the total
number of hours the engine has run. The hour meter
, R
ORWARD EVERSE
8). Press the horn button to
Figure 8
6. Engine
coolant-temperature light
7. Glow-plug-indicator light
8. Key switch
9. Power point
starts to function whenever you turn the key switch to
the O position or if the engine is running.
N
Battery Light
, and
The battery light is located to the right of the steering
column and above the oil light
light turns on for several seconds when you first start
the engine, and then turns off once the engine is
running. If the light remains on while the engine is
running, the alternator, battery, or electrical system
is damaged.
Engine Oil-Pressure Light
The engine oil-pressure light is located to the right of
the steering column
the operator if the engine-oil pressure drops below a
safe level to operate the engine. If the light comes
on and remains lit, shut off the engine and check the
engine-oil level. Add oil to the engine if necessary;
refer to Checking the Engine-Oil Level (page
Note:
The oil light may flicker; this is normal and no
action needs to be taken.
Engine Coolant-Temperature Light
The engine coolant-temperature light is located to
the right of the battery and the engine oil-pressure
lights, and above the glow-plug-indicator light
8). The engine coolant-temperature light warns the
operator that the coolant temperature of the engine is
too hot to continue operating the engine (the engine
is overheating). Shut off the engine and allow the
g027587
machine to cool down. Check the coolant level and
the belts to the fan and water pump. Fill the coolant
reservoir with coolant as needed and replace any
worn, damaged, or slipping belts.
Important:
persists, contact your Authorized Toro Dealer for
diagnostics and repair.
Glow-Plug-Indicator Light
The glow-plug-indicator light is located to the right of
the battery and the engine oil-pressure lights, and
below the engine coolant-temperature light
8). The glow-plug-indicator light illuminates red when
you rotate the key switch to the O
engine is cold. The light indicates that the glow plugs
are operating.
Key Switch
The key switch
off the engine, and has 3 positions: O
15
(Figure
(Figure 8). The oil light warns
If the engine overheating problem
N
(Figure 8), is used to run and shut
8). The battery
21).
(Figure
(Figure
position and the
, O , and
FF N