Setup; Installing The Steering Wheel (Model 07236Tc Only); Connecting The Battery (Model 07236Tc Only) - Toro Workman MDX-D Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
Note:
Determine the left and right sides of the machine from the normal operating position.
1
Installing the Steering
Wheel (Model 07236TC
Only)
Parts needed for this procedure:
1 Steering wheel
1 Cover
1 Washer (1/2 inch)
Procedure
1. If the cover is installed, remove it from the hub
of the steering wheel
2. Remove the locknut (1/2 inch) from the steering
shaft (Figure 3).
3. Slide the steering wheel and washer (1/2 inch)
onto the steering shaft
Description
Steering wheel
Cover
Washer (1/2 inch)
No parts required
No parts required
Operator's Manual
Engine owner's manual
Parts Catalog
Safety training material
Registration card
Predelivery Inspection Form
Certificate of Quality
Key
No parts required
(Figure 3).
(Figure 3).
Qty.
1
Install the steering wheel (Model
1
07236TC only).
1
Connect the battery (Model 07236TC
–
only).
Check the fluid levels and tire air
–
pressure.
1
1
1
Read the Operator's Manual and view
1
the training material before operating
1
the machine.
1
1
2
–
Burnish (break-in) the brakes.
4. Secure the steering wheel to the shaft with the
locknut (1/2 inch) and tighten it to 27 to 34 N·m
(20 to 25 ft-lb).
5. Install the cover on the steering wheel
1. Cover
2. Locknut (1/2 inch)
3. Washer (1/2 inch)
10
Use
(Figure
Figure 3
4. Steering wheel
5. Steering shaft
3).
g033840