Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
Note:
Determine the left and right sides of the
machine from the normal operating position.
1
Installing the Steering
Wheel
International Models Only
Parts needed for this procedure:
1
Steering wheel
1
Locknut
1
Wheel cover
3
Screw
Description
Steering wheel
Locknut
Wheel cover
Screw
No parts required
No parts required
Operator's Manual
Registration card
Predelivery Inspection Form
Certificate of Quality
Key
Qty.
1
1
Install the steering wheel (international
models only).
1
3
–
Check the fluid levels and tire pressure.
–
Burnish (break-in) the brakes.
1
1
Read the Operator's Manual and view
1
the setup material before operating the
machine.
1
2
Procedure
1.
Place the steering wheel on the steering shaft.
Ensure that the steering wheel is centered
(i.e., the flat bottom should be parallel with the
ground).
2.
Use the locknut to secure the steering wheel to
the steering shaft.
3.
Torque the locknut to 27 N∙m (20 ft-lb).
7
Use
Figure 3
g424446