Start-Up And Operation / Temperature Settings / Thermometer - Structural Concepts Impulse Series Installation & Operating Manual

START-UP AND OPERATION / TEMPERATURE SETTINGS / THERMOMETER

1. Case Start-Up

Plug cord into a certified electrical outlet with
ground.

Turn on the Main Power Switch. Switch is in the
Drop-In Refrigerated Section on the rear right
hand side of base.

The Temperature Control Module (LED) will
illuminate. Evaporator coil fans and the
compressor motor should turn on.

From the front of the case, raise deck to confirm
that the coil fans are functioning properly.

Turn on the lights. Light Switch is in the Upper
Display interior of the case at rear right side
(see illustration at right).

First time lighting may require a short warm up
period for the bulbs. Slightly dim or a flickering
of new bulbs is normal.
Spirit-Filled
Thermometer
Drop-In
Refrigerated
Section
Magnetic Filter (For Internal
Condensate Package)
2. Temperature Settings

This case has been tested to maintain a
temperature at or below 41 °F (5 °C)

When the merchandiser is in a start-up mode or
has been idle for a long period of time, the unit
requires 30 minutes in order to pull-down to
temperature.

Spirit-filled thermometer located in refrigerated
compartment is for monitoring warmest air
temperature in accordance with NSF® Std. 7.

The temperature is controlled by a temperature
control module. It is located at the lower-right
area (from case rear) of the drop-in refrigerated
section. See below for general location.

If a temperature setting change is required,refer to
instructions in the temperature controller section
of this operating manual.
Light Switch Inside
(at Top of Plenum)
Glass Shelf
Deck
9
Upper Display
Case
Main Power
"Rocker" Switch
ON
OFF
—– Main Power "Rocker"