Verify The Installation - Keysight Technologies N9030B Installation Note

Signal analyzer, option bba analog baseband iq inputs upgrade kit

Hide thumbs Also See for N9030B:

Verify the Installation

1. Turn on the analyzer and wait for the instrument to fully boot up.

2. Verify the spectrum analyzer application loads and sweeps as expected. Press System, Show

Hard ware on the analyzer and verify that the Main board and the

themselves as:

— BBIQ

— BBIQ Interface

3. Press System, Show System on the analyzer to display a list of all installed options. You

should see N9030B-BBA.

Before performing adjustments and performance verification tests using the N7814A Calibration

and Adjustment Software for Keysight RF and Microwave Instruments, press MODE/MEAS, I/Q

Analyzer (Basic), OK. Press Input/Output, Select Input, I/Q, I/Q, I/Q Cable Calibrate... on the

analyzer and follow the on-screen directions.

If the newly installed hardware is functioning properly the cable cal should work fine. Press

MODE/MEAS, Spectrum Analyzer, Swept SA, OK. Press Input/Output, Select Input, RF.

Installation Note N9030-90077

Option BBA, Analog Baseband I/Q Inputs Upgrade Kit

BBIQ Interface Board

identify

Table of Contents