Verify Hardware Installation - Keysight Technologies N9010B Installation Note

Installation Procedure

Verify Hardware Installation

1. Verify the spectrum analyzer application loads and sweeps as expected.
2. Press System, Show Hard ware on the analyzer and verify that the new DIF board identifies
itself as:
— Digital IF (Hw Id = 34)
Verify Optional Functionality
1. Press MODE/MEAS, I/Q Analyzer (Basic), OK.
2. Press MEAS SETUP, IF Path, and select the IF Path drop-down menu.
3. Verify that selections appear labeled "25 MHz" and "40 MHz".
4. Press AMPTD, Signal Path, uW Path Control.
5. Verify that selections appear labeled "Standard Path" and "uW Presel Bypass".
6. Tap uW Presel Bypass. If the path was previously set to Standard Path, you should hear a
click.
7. Tap Standard Path. If the path was previously set to uW Presel Bypass path, you should hear a
click.
44 Installation Note N9010-90065