Operation Without The Controller - Rinnai Symmetry RDV3611 Operation Manual

Operation without the controller

If you lose your controller, or the batteries go flat, you can still operate your fire using the control
panel on the unit.
Models with the control panel on the lower right hand side
Press and release the ON/OFF button. This will start the
electronic spark and the power LED will be illuminated.
The pilot will ignite first and then automatically go to the
high setting. Pressing the ON/OFF button again will turn
the unit off.
Under gas failure conditions, the appliance will go into
lock out after sparking for one minute. Under lock out the
power LED will remain on. To start the unit again, press
and release the On/Off button twice after the gas supply
resumes.
In the event of a power failure the Symmetry will turn off
and will need to be manually turned on again when power
is restored—this is a safety feature.
Models with the control panel on the side (premium flat frame)
Turning the fire on
Press the On/Off button once, you will hear the
electronic ignition sparker. The electronic ignition stops
when the pilot flame is established, the main burner then
ignites off the pilot and will go to the highest setting. The
LED power indicator will stay on, indicating the fire is
in operation. Flame height may be adjusted after one
minute of operation.
To change the burner and fan settings press the UP and
DOWN arrows to increase or decrease the flame height.
Turning the fire off
Press the On/Off button once. The LED power indicator
will turn off.
LED indicators
• On = blue
• Standby = red
• Off = nothing
Red power LED ON/OFF button
ON/OFF button
Blue LED indicator
Decrease
Symmetry RDV3611 operation guide: 11158-C 03-20 | 13
Increase