Symmetry Operation - Rinnai Symmetry RDV3611 Operation Manual

Symmetry operation

Your controller has as a built-in child lock function that requires pressing two buttons
simultaneously. This function cannot be overridden. To turn the controller on, press
PWR and OK at the same time. Pressing PWR will switch the controller off.
Fan
On start-up, the fan will start approximately four
minutes after the heater is switched on. This
delay is to reduce the amount of cold air being
pushed out into the room.
On shut-down, the fan will stop approximately
eight minutes after the heater is switched off.
This is to cool the appliance down.
Modes of operation
Your Symmetry has three modes of operation;
manual, automatic, and flame only mode. For
more information refer to p.10.
The fire is designed to run as efficiently as
possible. When in manual or automatic modes,
the fire will switch itself off if the room reaches
the set temperature, i.e. in smaller rooms that
heat up quickly. When this occurs, the flame
indicator on your controller will rise and fall
every few seconds to indicate the fire is still
operational. The unit will restart again once
the room temperature falls below the set
temperature.
ALWAYS check your wireless
controller before going to bed or
leaving the building to ensure the fire
IMPORTANT
has been switched off.
If you want your fire to operate regardless of
room temperature, adjust the controller to flame
controller mode only.
Start-up
When turning on the fire it will automatically
go to the highest setting for approximately 45
seconds—this is to establish the flame pattern.
You can adjust the fire during this time, but
there will be a 45 second delay.
Over temperature automatic shutoff
The controller when operating in any of the
three modes will automatically shutdown and
switch the fire off if the room temperature
exceeds 40 °C for more than three minutes—
this is a safety feature.
Power cut or power disruption
In the event of a power failure or
disruption, the Symmetry will turn off
and will need to be manually turned
on again when power is restored—
this is a safety feature.
To reset the fire, press the ON/OFF button on
the control panel, to turn the fire back on.
Symmetry RDV3611 operation guide: 11158-C 03-20 | 7