Connecting Devicenet Cables To Network; Connector - Toshiba 2000 V Series Manual

Chapter 3 Preparations for Operation (Hardware)
3.4.1 Connecting DeviceNet cables to network connector
3
32
(1) Preparing DeviceNet Cables
Prepare the DeviceNet cables to be connected to the network connector for the
DN611 so their ends will be an open type (2 power cables, 2 signal cables, and 1
drain cable are discrete, that is, separated at the end). If not, purchase cables
processed to have the open end described above.
Figure 3-5 Processing DeviceNet Cable Ends
(2) Connecting DeviceNet cables to the network connector
This section describes how to connect DeviceNet cables to the network connector
shown at left in Figure 3-4 (upper and lower rows of holes for inserting cables). As
shown in Figure 3-6, loosen the cable clamp screws in advance.
Be careful of the colors of the cable sheaths in inserting the cables into the network
connector of the matching colors. Then, tighten the cable clamp screws.
Black
黒
青
Blue
シールド/ドレイン
Shield/drain
Figure 3-6 Connecting Cables to Network Connector
Cable sheath color
5～7mm
About 30 mm
Colors printed
色表示
赤
白
Red
White
Cable clamp screws for the lower
下の段の穴のケーブル固定
row at the bottom
ネジはこちら側にあります
model 2000 DeviceNet Module Manual (DN611/DN611A)
Description
Black Network power line (V-)
Blue Signal line (CAN_L)
- Shield/drain
W hite Signal line (CAN_H)
Red Network power line(V+)
Cable clamp screws
ケーブル固定用ネジ