Toshiba 2000 V Series Manual page 104

Chapter 4 Operating Procedures for the DN611 (Software)
4
82
(4) Operation mode specifying information: 1 is significant in any of these bits.
F E D C B
0 0 0
STBY
RUN
Figure 4-18 Bit Configuration of Operation Mode Specifying Information
Table 4-15 Description of Operation Mode Specifying Information Bits
Bit Name
D STBY Standby request: Change from run mode to standby mode
C RUN Run request: Change from standby mode to run mode
A BITS Bit strobe transmission enable
9 POLL Polling transmission enable
4 START 1: Polling/bit strobe transmission start
S controller ↔ DN611 transfer mode
3 SYNC
1: Synchronous
(5) Others
• The following combinations of requests are inhibited in operation mode specifying
information
(a) Simultaneous requests of standby and run
(b) Requesting an existing mode (standby/run)
• For confirmation of actual mode changes, refer to station status.
• To change bits A, 9, 4, and 3, set the DN611 in standby mode, then request new
settings together with a run request.
• Standby cannot be requested when bits A, 9, 4, and 3 are set to 1.
A 9 8 7 6
0 0 0
BITS
POLL
Description
0: Asynchronous
model 2000 DeviceNet Module Manual (DN611/DN611A)
5 4 3 2 1
0 0 0
START
SYNC
0: Transmission stop
0
0