General Maintenance; Cleaning - biodex BALANCE SYSTEM SD Operation & Service Manual

13. GENERAL MAINTENANCE

The Biodex Balance System requires only the most basic general maintenance, performed on an
as-needed basis at least every three to four months.
CLEaNING INSTRuCTIONS
With the system turned OFF, wipe down all surfaces with a damp cloth. Mild soap and water
can be used to remove stains and scuff marks. As needed, inspect all locking and adjustment
mechanisms for signs of wear or damage.
If you have any questions or need further assistance, contact the Biodex Customer Service
Department.
GENERaL MaINTENaNCE PROCEDuRES
• Lubricate the spring assemblies with white lithium grease.
• Lubricate the eight push plates with white lithium grease.
• Lubricate the acme threaded rods with white lithium grease.
NOte: When checking for lubrication, it may only be necessary to re-distribute the existing grease.
CAUtION! Some steps of these procedure require the Balance System to be turned ON. When
this is the case, use extreme caution working on the system.
AtteNtION: Certaines étapes de la présente marche à suivre nécessitent que le système d'équili-
brage soit mis SOUS TENSION. En pareille circonstance, user de précautions extrêmes dans la
maniplation du système.
— 13-1 — GENERAL MAINTENANCE