Parts And Adjustments; To Adjust The Support Handle; To Adjust The Display Height; To Adjust The Display Tilt - biodex BALANCE SYSTEM SD Operation & Service Manual

4. PARTS AND ADJUSTMENTS

PaRTS aND aDjuSTMENTS
(See Figure 3.3.)
Mechanical adjustments to the Biodex Balance System are straightforward and uncomplicated.
In fact, there are only three adjustments that need be addressed to accommodate any patient:
Support Handle Position, Display Height and Display Tilt. All other test and exercise functions
are software controlled.

To adjust the Support Handle:

1. To position the Support Handle for patient use, hold the Support Handle while pulling out
on the Support Handle Release Pin. Rotate the handle to the desired position. Release the
pin to lock the Support Handle in place.
2. To release the Support Handle so that it cannot be used by the patient, hold the handle
while pulling out on the Support Handle Release Pin. Fully lower the handle, then release
the pin.
ajustement de l'appui
1. Pour régler l'angle de l'appui, le tenir tout en tirant sur le verrou. Trouver la position
voulue, relâcher le verrou pour garder la position ainsi trouvée.
2. Pour écarter l'appui, le baisser tout en tirant sur le verrou.

To adjust the Display Height:

1. Loosen the Display Height Locking Knob.
2. Pull up or push down on the display until the desired height is achieved.
3. Tighten the locking knob to secure the display in the desired position.
NOte: Position the display so that the patient can look straight at it. This will help ensure good posture
during the test or exercise session.
Pour adjuster la hauteur de l'ecran
1. Desserrer la mollette de réglage de hauteur.
2. Déplacer l'écran à la hauteur voulue.
3. Serrer la mollette.

To adjust the Display Tilt:

1. Simply tilt the Display as required by patient or testing/exercise protocol.
ajustement de l'inclinaison de l'ecran
1. Pivoter l'écran pour obtenir l'angle voulu.
— 3-3 — ASSEMBLY & INSTALLATION