Step 3: Installing The Media Holders And Media Stays - Roland TrueVIS VF2-640 Setup Manual

1. Assembly and Ink Filling

Step 3: Installing the Media Holders and Media Stays

IMPORTANT: Be sure to follow the procedure.
After finishing
perform
P. 32 "Step 3: Installing the Media Holders and Media Stays"
results will be affected because the media holders will not be installed in the correct positions.
1.
Attach the arms.
A
Temporarily tighten the (short) bolts on the left side of the stand as seen from the rear of
the printer.
Tighten the (short) bolts in the holes on the side of the stand until you can see approximately 5 mm
(0.2 in.) of their threads on each side.
B
Attach the left arm to the temporarily tightened (short) bolts.
Point
Each arm can only be used on either the left or right side. Attach them on the correct sides.
32
2.Installation
P. 25 "Step 1: Assembling the Stand"
Arm (left)
and
P. 28 "Step 2: Assembling the Printer Unit and the Stand"
. If this procedure is not followed, printing
Approx. 5 mm
(0.2 in.)
Arm (right)
,
Tighten
temporarily
Bolts (short): 2
Rear