Roland TrueVIS VF2-640 Setup Manual page 57

2.
Set the subnet mask.
A
Press [ ] to display the screen shown below.
NETWORK
SUBNET MASK
B
Press [ ] twice to display the screen shown below.
SUBNET MASK
0. 0.
C
Press [ ] or [ ] to select the address number.
D
Press [ ].
E C
Repeat steps
Note: For the subnet mask, make the setting the same value as the one used by the computer. Here,
"255.255.255.0" is entered by way of example.
SUBNET MASK
255.255.255.
F
When you have finished making the setting, press [ENTER].
G
Press [ ] to go back to the screen shown below.
NETWORK
SUBNET MASK
If you are using the computer and the machine on a one-to-one basis, this completes the settings to make on the
printer.
Press [MENU] to go back to the original screen. Then, proceed to
.
RIP"
If you need to set the gateway address, proceed to the following procedure.
0. 0
D
and to set [SUBNET MASK] to "255.255.255.0."
0
P. 56 "Step 3: Make the Port Settings for the Software
2. Network Settings
55
2.Installation