Table of Contents
Advertisement
1. Assembly and Ink Filling
D
Make sure the drain bottle is installed, and then press [ENTER].
P. 39 "Step 4: Installing the Drain Bottle"
INSTALL
DRAIN BOTTLE
The screen shown below appears, and then the machine starts the preparations for the ink filling. The
(approximate) remaining time for the procedure is displayed on the screen. (The display shown below is
an example. "20:00" = "20 minutes and 00 seconds")
FILLING INK...
>>>>>
MEMO
If the screen shown below appears here, pouch trays remain in the ink slots. Remove all the pouch trays.
REMOVE CARTRIDGE
12345678
3.
Fill with ink.
A
Gently shake the ink pouch for each color. Shake the white ink pouch 50 times (for around
20 seconds).
The precipitation of the ingredients in the ink disables printing in normal color. So that the ink mixes well,
shake the pouch tray horizontally with a stroke length of around 5 cm (2 in.) from each end of the tray.
• Do not remove the ink pouches. Shake the entire pouch tray. Removing the ink pouches may
lead to the ink leaking.
• Before shaking, wipe off any ink from around the mouth of the ink pouch. If you do not wipe off
the ink, it may splatter when you shake the pouch tray.
B
When the screen shown below appears, set the pouch tray in which you have set an ink
pouch in the ink slot whose number is flashing.
SET CARTRIDGE
12345678
48
2.Installation
20:00
Advertisement
Table of Contents
