1. Assembly and Ink Filling
C
Fully tighten the bolts in the 4 upper locations and then in the 4 locations on the sides.
Use the pipe when tightening the bolts in the upper locations. When tightening the (short) bolts fully,
tighten them securely. Loose (short) bolts may cause the stand to wobble.
D
Assemble the opposing stand leg by following the same procedure from step
E
Position the stand legs parallel to each other and separated by approximately 1,800 mm
(70.9 in.).
Position the legs so that the L-shaped brackets face the inside and the bent side of the tabletop plate
faces down for each leg.
F
Place the stand stay on the stand legs.
26
2.Installation
About 1,800 mm (70.9 in.)
Set this part on the bottom.
Pipe
Position the surface with attachment
holes toward the casters.
Tighten fully
Bolts (short): 8
A
C
to step
.