Roland TrueVIS VF2-640 Setup Manual page 35

C
Lightly tighten the bolts connecting the rear of the stand to the arm's contact surface.
While pressing the side of the arm onto the stand leg, tighten the (short) bolts.
D
Fully tighten the bolts in the order of
E
Attach the other arm to the right side as seen from the rear of the machine.
F
Attach the media holder adjuster to the right arm as seen from the rear of the machine.
Pass the protrusions of the media holder adjuster
temporarily tighten the bolts so that the media holder adjuster does not fall off.
1 2
(stand rear), (stand side).
2
through the notches on the arm
1. Assembly and Ink Filling
Tighten
temporarily
Bolts (short): 2
Tighten fully
Bolts (short): 4
1
, and then
Tighten
temporarily
Bolts (short): 2
2.Installation
33