Table of Contents
Advertisement
Specifications
*1
The media holders of this machine are designed to be used exclusively with media that has a paper tube (core) with an
inner diameter of 3 inches� To use 2-inch media, the optional media flanges are required�
*2
The length of printing is subject to the limitations of the application software�
*3
• Media type: Media specified by Roland DG Corporation
• Temperature: 25°C (77°F), humidity: 50%RH
• Roll media must be loaded correctly�
• Excluding expansion/contraction of the media
• Not assured when the print heater or dryer is used�
• Assumes all correction and adjustment functions of the machine have been used properly
• Print travel: 1 m (39�4 in�)
*4
• Warm-up is required after power up� This may require 5 to 20 minutes, depending on the operating environment�
• Depending on the ambient temperature and the media width, the set temperature may not be reached�
*5
• Operating environment
Humidity
(no condensation)
60
3.Appendix
Use in an operating environment
within this range�
Temperature °C (°F)
Advertisement
Table of Contents
