Roland TrueVIS VF2-640 Setup Manual page 36

1. Assembly and Ink Filling
G
Attach the adjustment bolt
H
Tighten the bolt until the bottom of the right arm and the bottom of the media holder
adjuster are aligned
MEMO
At the end of the installation work, a suitably qualified worker will adjust the media holder adjuster.
Leave this work to the suitably qualified worker.
2.
Attach the media holders.
A
Place the shafts on the arms.
First insert the shafts into the holes on the right side as seen from the rear of the machine, and then
place the shafts into the holes on the left side.
34
2.Installation
1
.
2
.
Adjustment bolt
Media holder
adjuster
Arm
Align the bottom of the
media holder adjuster
with the bottom of the
arm.
Tighten fully
Adjustment bolt: 1