Switching On The Alarm System (Burglar Alarm System = Ema); Testing The Activation Process; Switching Off The Alarm System; Activation Transponder - Simons Voss Technologies VdS Block lock Manual

VdS Block lock

3.1 Switching on the alarm system (burglar alarm system = EMA)

3.2 Testing the activation process

3.3 Switching off the alarm system

3.4 Activation transponder

(Manual)
1. The person authorised to activate operates his transponder near an ac-
tivation unit twice in quick succession (within two seconds). This sends
a signal to all existing deactivation units.
2. If latch contacts are connected to the deactivation units, the deactiva-
tion units first check whether the doors are correctly locked. If this is the
case, the digital locks are deactivated, making it impossible to enter the
security area.
Only after successful deactivation of all locks does the activation unit
receive a positive acknowledgement and the activation master switches
the alarm system on externally via a potential-free contact (principle of
inevitability). When the alarm system has been activated, the LEDs of
the activation units light up for 2.5 seconds. At the same time the test
LEDs of the deactivation units go out.
3. The EMA itself indicates the successful activation acoustically (e.g. on
the activation unit).
If the person authorised to activate the alarm has activated his
transponder near an activation unit once, the activation unit signals the
status of the alarm system with the LEDs:
One short, long flash: Alarm system is deactivated.

Flashing once long (2.5 seconds): Alarm is activated.

1. The person authorised to activate activates his transponder again twice
in quick succession (within two seconds) near an activation unit. The
activation unit deactivates the alarm system again and flashes once
briefly and long.
2. The deactivation units activate the locks and the test LEDs light up
again.
3. Authorised transponders now open every door again.
In the LSM via | Programming | und Special functions - Activation
transponder you can create an empty transponder as an activation
transponder for emergencies. This can temporarily activate all locks in the
locking system.
3. Description of functions
11 / 52