Table of Contents
Advertisement
How to configure two NetBackup 52xx or 53xx appliances in different domains for MSDP replication
How to configure two NetBackup 52xx or 53xx
appliances in different domains for MSDP
replication
3
Connect an available target port from any Fibre Channel card on the 50xx, to
an available initiator port on any Fibre Channel card on the NetBackup 52xx
or 53xx.
See
"Supported Fibre Channel port configurations for the NetBackup 53xx
appliances"
on page 47.
See
"Supported Fibre Channel port configurations for the NetBackup 5220 and
5230 appliances"
on page 37.
See
"Supported Fibre Channel port configuration for the NetBackup 5240 appliances"
on page 43.
This topic describes how to establish the replication relationship between a
NetBackup 52xx or 53xx appliance in an originating domain and a NetBackup 52xx
or 53xx appliance in a target domain. The process is very similar to traditional
(non-appliance) NetBackup environments that use Media Server Deduplication
Pool (MSDP) replication in different domains.
Successful configuration requires that you perform other tasks that are documented
in the NetBackup Deduplication Guide.
The following table describes the steps to configure two NetBackup 52xx or 53xx
appliances in different domains for MSDP replication. References to other tasks
are also included.
Steps to configure two NetBackup 52xx appliances in different
Table 4-5
domains for MSDP replication
Step
Task description
1
On one of the NetBackup 52xx or 53xx appliances, log in to the NetBackup
Appliance Shell Menu.
2
Obtain the NetBackup deduplication password of the domain by running the
following command:
Main > Appliance > ShowDedupePassword
Record this password for later use in Step 4.
3
On the local NetBackup master server, log in and start the NetBackup
Administration Console.
Configuring Fibre Transport on the appliance
76
Advertisement
Table of Contents
