Table of Contents
Advertisement
About Fibre Transport media server verification
To configure four ports as target ports, run the following command:
■
Main > Manage > FibreChannel > Configure 4
4
If you want to disable the SAN Client FTMS feature, run the following command:
Main > Settings > FibreTransport SANClient Disable
5
After the appliance has been restarted, verify the SAN Client FTMS settings
as follows:
Log on to NetBackup Appliance Shell Menu
■
Run the following two commands:
■
Main > Settings > FibreTransport SANClient Show
Verify that the settings are correct.
■
The following is the ouput when the feature is enabled:
- [Info] Fibre Transport Sever enabled.
The following is the ouput when the feature is disabled:
- [Info] Fibre Transport Sever disabled.
See
"Settings > Network > Fibre Transport"
See
"Supported Fibre Channel port configurations for the NetBackup 5220 and
5230 appliances"
on page 37.
See
"Supported Fibre Channel port configurations for the NetBackup 53xx
appliances"
on page 47.
See
"Supported Fibre Channel port configuration for the NetBackup 5240 appliances"
on page 43.
After you install and configure a Fibre Transport (FT) media server, you can use
the
>
Settings
FibreTransport SANClient Show
of the SAN Client feature. When you run the
command and the Fibre Transport (FT) media server is configured properly, you
see an output similar to the following:
Testsys.Settings> FibreTransport SANClient Show
Fibre Transport server installed and running.
Configuring Fibre Transport on the appliance
About Fibre Transport media server verification
on page 59.
command to show the status
FibreTransport SANClient Show
65
Advertisement
Table of Contents
