Configuring Fibre Transport To Other Netbackup Appliances - VERITAS NetBackup Series Manual

Step Action
Step 4 Create FT storage zones.
Step 5 Configure FT settings for optimized
duplication and Auto Image
Replication.
Configuring Fibre Transport to other NetBackup
appliances
FT configuration process for optimized duplication and Auto Image
Table 4-4
Replication over FC (continued)
Description
Select HBA ports and learn about zoning best practices.
See
Determine the appliance HBA WWPNs for zoning.
See
Configure FT settings on the source appliance.
See
on page 68.
Configure FT settings on the targe 52xx and 53xx appliance.
See
duplication and replication"
Note:
the target appliance, see the NetBackup Deduplication Appliance
Software Administrator's Guide
See "How to configure two NetBackup 52xx or 53xx appliances in different domains
for MSDP replication"
Use the following procedure to configure Fibre Transport (FT) to other NetBackup
appliances.
Note: When the FT for replication to other NetBackup appliances is enabled or
changed, the deduplication storage daemons require a restart. It is recommended
that you first suspend or cancel all jobs before you enable or change this setting.
To configure Fibre Transport to other NetBackup appliances from the
NetBackup Appliance Web Console
1
Log on to the NetBackup Appliance Web Console.
2
Click Settings > Network, then select Fibre Transport.
Configuring Fibre Transport on the appliance

Configuring Fibre Transport to other NetBackup appliances

"About zoning the SAN for NetBackup appliances"
"How to determine appliance HBA WWPNs"
"Configuring Fibre Transport to other NetBackup appliances"
"Configuring Fibre Transport on a target appliance for optimized
For configuring the NetBackup 5020 and 5030 appliances as
on page 76.
on page 51.
on page 71.
68
on page 51.