Supported Fibre Channel Port Configurations For The Netbackup 53Xx Appliances - VERITAS NetBackup Series Manual

Supported Fibre Channel port configurations for
the NetBackup 53xx appliances
Note: Before you start configuring a particular FC feature on the appliance, make
sure that it is supported with your appliance HBA configuration.
See
on page 14.
The NetBackup 53xx appliance contains six populated PCIe card slots. Each slot
contains either a Fibre Channel (FC) HBA card or an Ethernet card.
Figure 2-4
HBA cards.
Figure 2-4
Note: NetBackup 5340 appliance has the same FC HBA configuration and HBA
port order as a NetBackup 5330 appliance.
Note: Veritas does not support reconfiguring the FC HBA cards in the appliance
rear panel. Do not switch cards in different slots or install a used card from another
appliance without contacting Veritas Technical Support.
Table 2-7
options.

Supported Fibre Channel port configurations for the NetBackup 53xx appliances

"About Fibre Channel feature support with appliance HBA configurations"
shows the PCIe slot locations and the port order for the installed FC
NetBackup 5330 PCIe slot locations and FC HBA port order
NetBackup 5330
FC HBA port order for all slots
Port 2 (left)
describes the supported card type for each slot and the supported FC
About the HBA port mode configuration
Slot 3 (10Gb NIC or 8Gb FC HBA)
Slot 2 (10Gb NIC or 8Gb FC HBA)
Slot 1 (FC-reserved)
Port 1 (right)
Slot 6 (10Gb NIC or 8Gb FC HBA)
Slot 5 (10Gb NIC or 8Gb FC HBA)
Slot 4 (FC-reserved)
47