Configuring Fibre Transport Media Sever Settings - VERITAS NetBackup Series Manual

Step Action
Step 1 Determine whether your appliance
HBA configuration supports FTMS.
Step 2 Learn about SAN Client and FTMS
for NetBackup appliance.
Step 3 Learn about HBA port reservation
and default port mode for FTMS.
Step 4 Create Fibre Transport (FT) backup
zones.
Step 5 Enable FTMS on the appliance.

Configuring Fibre Transport media sever settings

FT media server configuration process
Table 4-3
Description
Identify your appliance HBA configuration.
See
on page 18.
See
on page 20.
See
configuration options"
Determine whether your appliance HBA configuration supports FTMS.
See
configurations"
See
See
mode configuration"
Select HBA ports and learn about zoning best practices.
See
Determine the appliance HBA WWPNs for zoning.
See
To use FT for backups to the appliance, you must enable FTMS on
the appliance.
See
See "About Fibre Transport paths for NetBackup appliances"
Note: Enabling or changing the SAN Client FT settings requires a restart of the
appliance. Before you enable or change these settings, it is recommended that you
first suspend or cancel all jobs.
The following describes the FC HBA cards that are affected:
NetBackup 5220 - FC HBA cards in slots 2 and 4
■
Configuring Fibre Transport on the appliance
Configuring Fibre Transport media sever settings
"About the NetBackup 5230 rear panel configurations"
"NetBackup 5240 Appliance I/O configuration options"
"NetBackup 5330 Appliance compute node PCIe slot I/O
on page 23.
"About Fibre Channel feature support with appliance HBA
on page 14.
"About NetBackup SAN Client and Fibre Transport"
"About FTMS reserved HBA ports and the factory default port
on page 32.
"About zoning the SAN for NetBackup appliances"
"How to determine appliance HBA WWPNs"
"Configuring Fibre Transport media sever settings"
on page 9.
on page 51.
on page 51.
on page 63.
on page 27.
63