Install the Foot Switch
Foot Switch Installed
FIGURE 4.
Select a suitable location for the foot switch (P/N 063-0172-470) to be installed.
1.
Note:
The foot switch should be installed in a location where the operator has easy access to it and is
able to fully press the pedal.
Using the holes in the foot switch as a template, drill holes in the floor of the cab.
2.
Secure the foot switch to the floor by installing the supplied screws in each of the mounting holes.
3.
Install the Node Harness
Node Harness Installed
FIGURE 5.
Install the two large, rectangular connectors of the node harness (P/N 115-4001-109) into the correct ports
1.
of the node.
Tighten the bolts on the harness connectors to secure the connections.
2.
Locate the ENABLE connector and connect it to the foot switch cable connector.
3.
Manual No. 016-5034-005
Cab Component Installation
27