Raven SmarTrax Calibration & Operation Manual page 15

Ros

Hide thumbs Also See for SmarTrax:

Table of Contents

FIGURE 5. Serial Device Setup Screen

1. Select Edit.

2. Select Serial Devices.

3. Press the Retry button in the bottom-right corner of the screen. The following screen will appear:

4. Verify that the SmarTrax and 600S are listed in the Serial Device Setup screen.

NOTE:

If SmarTrax and 600S is not visible in the list, inspect cable connections to ensure they are installed

securely, then press the Retry icon again. Refer to Chapter 4, Troubleshooting beginning on page 41

for further information.

5. Press Accept.

P/N 016-9001-022 Rev. D

Edit

Serial Devices

VIPER 4

Table of Contents