Wheel Angle Sensor Installation; Assemble The Wheel Angle Sensor (Was) - Raven SmarTrax Installation Manual

CHAPTER
4

Assemble the Wheel Angle Sensor (WAS)

WAS Assembly
FIGURE 1.
Install the M10 stud linear sensor mount (P/N 103-0001-030) and M10 jam nut (P/N 312-1002-035) on the
1.
base-end (where the cable is connected) of the 250 mm non-contact linear wheel angle sensor (WAS) (P/N
063-0181-017).
Install the M10 ball linear sensor mount (P/N 103-0001-029) on the rod-end of the WAS using the remaining
2.
M10 jam nut.
Manual No. 016-5034-005
W heel Angle Sensor
C h a p t e r 4
Installation
19