Operating Modes - UTC Fire and Security Kidde AirSense SynaG Series Installation Manual

Operating modes

Supported operating modes are shown in the table below. The default operating
mode is EN 54-2 (with EN 54-13 supervision disabled).
Table 2: Operating modes
Operating mode
EN 54-2 (default)
EN 54-2 Evacuation
EN 54-2 Scandinavia
BS 5839-1 (No 2nd stage)
BS 5839-1 (2nd stage)
NBN S 21-100
NEN 2535 [2]
[1] EN 54-13 supervision requires compatible system wiring and devices and must be enabled
by the installer in the control panel configuration.
[2] Requires a 2010-1-SB expansion board to be installed (not supplied).
SynaG Series Installation Manual
EN 54-13 option Region
available [1]
Yes European Union
Yes European Union (Spain)
Yes European Union (Scandinavia)
No United Kingdom
No United Kingdom
Yes Belgium
Yes The Netherlands
Chapter 1: Introduction
3