Expansion Board Configuration; Adding An Expansion Board - UTC Fire and Security Kidde AirSense SynaG Series Installation Manual

3. Press Enter.
4. The software version is displayed in three consecutive segments, as shown
below.
Segment Description
Is the major release identifier
Is the minor release identifier
Is the version cycle number
In the above example, the reading is for software version 1.1.7.

Expansion board configuration

Adding an expansion board

Use this menu, available from the basic or advanced configuration menus, to
configure the number of installed expansion boards. The default value is 00.
To add an expansion board:
1. Set the display as shown below, and then press Enter.
The Expansion I/O Fault/Disabled LED flashes fast to indicate that the
module configuration menu is active.
2. Select a value using the value selection buttons (2 and 4).
3. Press Enter.
4. Save your changes.
The maximum number of expansion boards that can be installed is shown below.
Table 26: Maximum number of expansion boards
Two- and Four-zone control panels
Eight-zone control panel
[1] Note: For regulatory compliance, when a fire network board is installed, make sure your
configuration does not exceed the usage of three expansion board modules.
SynaG Series Installation Manual
Chapter 3: Configuration and commissioning
Example
Up to two expansion boards
Up to four expansion boards [1]
51