User Interface For Eight-Zone Control Panels - UTC Fire and Security Kidde AirSense SynaG Series Installation Manual

Chapter 3: Configuration and commissioning

User interface for eight-zone control panels

Figure 17: User interface for eight-zone control panels
Legend
1. Zone buttons and LEDs (Z1, Z2, etc.)
2. Supply LED
3. General Fault LED
4. General Fire Alarm LEDs
5. Sounder Fault/Disable/Test button and
LED
6. Sounder Delay button and LED [2]
7. Networking Fault LED
8. Reserved for special use [2]
9. Expansion I/O Fault/Disabled LED
10. General Disable button and LED
11. General Test button and LED
Notes
[1] Two-zone control panels do not support fire routing or warning sounders for NEN 2535.
[2] Regional variants include changes to interface buttons and LEDs. See Table 16 on page 27.
26
12. Configuration controls
13. Reset button and LED
14. Panel Silence button and LED
15. Sounder Start/Stop button and LED
16. System Fault LED
17. Out of Service LED
18. Earth Fault LED
19. Supply Fault LED
20. Fire Routing Delay button and LED [2]
21. Fire Routing ON/ACK and
Fault/Disable/Test button and LEDs [2]
SynaG Series Installation Manual