Expansion Board Configuration - UTC Fire and Security Kidde AirSense SynaG Series Installation Manual

Table of Contents

Chapter 3: Configuration and commissioning

Expansion board configuration

Expansion board labels

For configuration purposes expansion boards are labeled A and B (for two- and

four-zone control panels) or A, B, C, and D (for eight-zone control panels).

The label for a given module is defined by its position (left to right) in the control

panel cabinet, The first expansion board installed is module A, the second B, etc.

See your expansion board installation sheet for installation instructions.

Expansion board function and delay configuration

Once an expansion board is installed and added to the control panel

configuration, the following additional configuration options appear on the basic

and advanced configuration menus.

Note:

These configuration options are repeated for each of the installed

expansion boards (A, B, C, and D).

Table 27: Expansion board A configuration options

Display

Description

Module A function

Module A output 1 delay

Module A output 2 delay

Module A output 3 delay

Module A output 4 delay

[1] Available values depend on the type of expansion board installed and the supervision

selected. See Appendix A "Configuration presets" on page 79.

Expansion board function

Use this menu to configure the expansion board function. The default value

depends on panel configuration. For most configurations, the default value is 01.

For two-zone panels, or panels configured for EN 54-13, the default is 05. For the

available presets, see Appendix A "Configuration presets" on page 79.

To configure the expansion board function:

1. Set the display as shown below, and then press Enter.

Value

01 to 92 [1]

00 to 10 minutes

SynaG Series Installation Manual

Table of Contents

Table of Contents