The user interface
Consult the operator manual for details on the different controls and indications
provided by the control panel.
User interface for two- and four-zone control panels
Figure 16: User interface for two- and four-zone control panels
Legend
1. Zone buttons and LEDs (Z1, Z2, etc.)
2. Supply LED
3. General Fault LED
4. General Fire Alarm LEDs
5. Sounder Fault/Disable/Test button and
LED
6. Sounder Delay button and LED [2]
7. Networking Fault LED
8. Reserved for special use [2]
9. Expansion I/O Fault/Disabled LED
10. General Disable button and LED
11. General Test button and LED
Notes
[1] Two-zone control panels do not support fire routing or warning sounders for NEN 2535.
[2] Regional variants include changes to interface buttons and LEDs. See Table 16 on page 27.
SynaG Series Installation Manual
Chapter 3: Configuration and commissioning
12. Configuration controls
13. Reset button and LED
14. Panel Silence button and LED
15. Sounder Start/Stop button and LED
16. System Fault LED
17. Out of Service LED
18. Earth Fault LED
19. Supply Fault LED
20. Fire Routing Delay button and LED [1][2]
21. Fire Routing ON/ACK and
Fault/Disable/Test button and LEDs [1][2]
25