Configuration Overview; Configuration Controls - UTC Fire and Security Kidde AirSense SynaG Series Installation Manual

Chapter 3: Configuration and commissioning
User level passwords and indications
The default user level passwords and the corresponding LED and seven-
segment display indications are shown in the table below. The seven-segment
display is only visible when the control panel cover is removed. See Figure 1 on
page 6 and Figure 2 on page 7.
Table 17: User level passwords and indications
User level Password
Public None
Operator 2222
Basic installer 3333
Advanced 4444
installer
Note: If you have used advanced configuration options to set a custom input
configuration, zone delay, zone configuration, or zone type, then the seven-
segment display defaults to the custom display operating mode. See "Panel
mode" on page 34 for details.

Configuration overview

To facilitate rapid configuration of the most common tasks, configuration is
divided into basic and advanced levels.
For basic configuration options, see "Basic configuration" on page 31. For
advanced configuration options see "Advanced configuration" on page 39.
Note: The reset and panel silence functions are not available in configuration
mode. To reset the control panel or silence the internal buzzer, first exit
configuration mode. See "Common configuration tasks" on page 30 for
instructions on exiting from configuration mode.

Configuration controls

The control panel is configured using the front panel configuration controls and
the seven-segment display. The configuration controls are also used to enter the
user level password.
The configuration controls
The configuration controls are located on the control panel interface.
28
LED
None
The Reset LED is
steady
The Reset LED is
flashing
The Reset LED is
flashing
Default display Custom display
None None
None None
SynaG Series Installation Manual