Fire Network And Repeaters Configuration - UTC Fire and Security Kidde AirSense SynaG Series Installation Manual

The Expansion I/O Fault/Disabled LED on the control panel interface and the
ON LED on the expansion board flashes fast to indicate that the module
function configuration menu is active.
2. Select a value from 01 to 92 using the value selection buttons (2 and 4).
3. Press Enter.
4. Save your changes.
Expansion board output delay
Use this menu to configure an expansion board output delay of up to 10 minutes,
where the feature is available.
To configure an expansion board output delay:
1. For output 1 on expansion board A, set the display as shown below, and then
press Enter.
The Expansion I/O Fault/Disabled LED on the control panel interface and the
Activated LED on the expansion board flashes fast to indicate that the module
delay menu is active.
2. Select a value from 00 to 10 using the value selection buttons (2 and 4).
3. Press Enter.
4. Repeat steps 1 to 3 as required for each output (1 to 4) on each installed
module (A, B, C, and D) where a delay is required.
5. Save your changes.

Fire network and repeaters configuration

This section describes how to configure a fire network of conventional control
panels in order to:
• Connect repeaters (any conventional control panel can be configured to
operate as a repeater)
• Create a fire network of conventional control panels, when you need
additional conventional zones in your system
• Create a network including compatible addressable control panels, to add
more features to your fire detection and alarm system (e.g. logging events,
complex output activation controlled by the addressable system, remote
monitoring)
When a conventional panel is connected to a fire network it normally displays the
status of one or more panels in the network (depending on repeater configuration
SynaG Series Installation Manual
Chapter 3: Configuration and commissioning
53