wtw inoLab Cond 730 Operating Manual page 20

Operation
AutoRead AR
(Drift control)
20
The AutoRead function (drift control) checks the stability of
the measurement signal. The stability has a considerable ef-
fect on the reproducibility of the measured value.
1 Call up the measuring mode by pressing
2 Activate the AutoRead function by pressing
The current measured value is frozen (Hold function).
3 Start the AutoRead function by pressing
AR flashes on the display until a stable measured
value is reached.
This measured value is transmitted to the printer/
interface.
4 If necessary, start the next AutoRead measurement
by pressing
5 To terminate the AutoRead function: Press the
key.
Note
The current AutoRead measurement (with acceptance of
the current value) can be terminated at any time by
g
pressing .
g
.
Cond 730
m
.
a
.
g
.
a