Authorized Use; General Safety Instructions - wtw inoLab Cond 730 Operating Manual

Safety
Function and
operational safety
10
2.1

Authorized use

This instrument is authorized exclusively for measuring the
conductivity, salinity, temperature and TDS (total dissolved
solids) in the laboratory.
The technical specifications as given in the chapter
7 T
ECHNICAL DATA
and running of the measuring instrument according to the
instructions given in this operating manual is authorized.
Any other use is considered unauthorized.
2.2

General safety instructions

This instrument is constructed and tested in compliance with
the EN 61010-1 safety regulations for electronic measuring
instruments.
It left the factory in a safe and secure technical condition.
The smooth functioning and operational safety of the instru-
ment can only be guaranteed if the generally applicable
safety measures and the specific safety instructions in this
operating manual are followed.
The smooth functioning and operational safety of the instru-
ment can only be guaranteed under the climatic conditions
specified in the chapter 7 T
If the instrument was transported from a cold environment to
a warm environment, the formation of condensate can lead
to the faulty functioning of the instrument. In this event, wait
until the temperature of the instrument reaches room tem-
perature before putting the instrument back into operation.
Caution
The instrument is only allowed to be opened by personnel
authorized by WTW.
must be observed. Only the operation
ECHNICAL DATA
Cond 730
.