Advertisement
93.
Position Window Trim around window doing a dry run first and attach with 4 - 1 1/2" finishing nails
per piece. Each Window Trim Kit contains 1 x 24 1/16" = Top Piece (angle cut on ends) and
3 x 23" = Side & Bottom Pieces. Window trim has a small dado on reverse face. Outside flange of
window will roughly sit in the dado to give a better fit.
94.
Attach Door Hinges to Top and Bottom Dutch Door sections. Top Door has trim overhanging
door at bottom while bottom door has trim recessed slightly. Hinges should be centered on door trim
with barrel nudged to end of trim. Use 2" & 3/4" black headed screws as shown above.
View from inside
3/8" gap at bottom.
Evenly spaced on
sides.
Floor Plywood
95.
Place Bottom Dutch Door panel into
position. Gap 3/8" on bottom, evenly space
on sides, and attach hinge to Front Wall
Trim/Support with 2" black headed screws.
Use shim to help keep the door evenly
spaced on bottom. One of the extra roof
shingles (see parts list) can be used.
Toll Free 1-888-658-1658
Trim dado
sits in flange.
Bottom Door
www.outdoorlivingtoday.com
2" Screws
1/4" gap
on inside.
Slight gap.Top Trim overlaps
bottom trim to prevent water
from getting in.
96.
Place the Top Dutch Door Panel into place
and gap top and bottom trims on the outside
about 1/8" apart. On the inside, horizontal door
frames should be about 1/4" apart. Use a shim
once again to help you. Attach hinges to Front
Wall Trim/Support with 2" black headed screws
provided.
Page 42
Bottom Door Trim
Middle Hinges
centered on trims.
2" Black
Screws
sales@outdoorlivingtoday.com
Advertisement
