Advertisement
35.
Lift up the rear completed gable section
and place on top of rear walls.
36.
Position the Rear Gable Wall on top of the Rear Top
Plate. The rear gable framing should sit flush with the
inside of the top plate. It should also be centered sideways
on the top plate. Hint: use a straight edge to check the
angle of the gable framing and top plate. Both angles
should line up. Adjust gable accordingly. Temporarily
attach to walls and Top Plate with 2 - 2" screws. Gables
may need slight adjustment in Step 50. Complete
attachment in Step 50 with additional 8 - 2" screws. Screw
from the bottom of gable framing down into Top Plate and
Wall.
Gable Notch
37.
Locate both Middle Gable Walls and attach together as per Step 32.
38.
Position the Middle Gable Wall on top of front top plate. Middle gable has cedar siding on the
front that is cut flush with gable framing. Once again, the framing of the gable should be flush with
outside of plate and be centered sideways on the plate. When in correct position, attach with
2 - 2" temporary screws as per Step 36.
Later in Step 50, complete attachment with 8 more 2" Screws.
Toll Free 1-888-658-1658
Filler
Shingles
Siding is
flush with
framing
www.outdoorlivingtoday.com
Page 18
sales@outdoorlivingtoday.com
Advertisement
