Advertisement
49.
At the peak, align Ridge Boards
so they are flush together and secure
them with 12 - 1 1/4" screws.
Important: if there is a gap between
Ridge Boards, try pushing side walls
closer together from outside. Walls
should be 91" apart at top from inside
of wall plate to wall plate.
completely secure Ridge Boards,
place 4 - 1 1/4" screws into any of the
remaining
Metal
Connector holes. Complete both
sides.
50.
With both Rafter Ridge Boards
connected, completely secure Rafters to
Gable framing of both rear and middle
Gable Walls. Use 8 - 2" screws per
gable.
Toll Free 1-888-658-1658
To
Ridge
Board
www.outdoorlivingtoday.com
Offsetting Metal
Important: Make sure Metal Ridge
Ridge Board
Board Connectors are offset to one
Connectors
another as illustrated to the left.
sales@outdoorlivingtoday.com
Page 23
Important: - If Gable
framing does not line up
with
Rafters,
remove
temporary 2" screws from
gable framing. Re-align
gable and secure with
8 - 2" screws total.
Advertisement
