Routing Cables - Huawei UPS2000-A-RTL Series User Manual

UPS2000-A-(6 kVA-10 kVA)-RTL
User Manual
Step 3 Install mounting ears and devices from bottom up, as shown in the following figure.
Step 4 Connect cables. For details, refer to the section "Connecting Cables."
----End

3.2.2 Routing Cables

Determine the installation positions and route cables. The UPS can be tower-mounted or rack-
mounted. A maximum of four battery packs can be configured. Place the battery packs
together based on site requirements. If the UPS is tower-mounted, place the battery packs on
the left or right of the UPS. If the UPS is rack-mounted, place the battery packs over or under
the UPS. This section describes how to route cables for two battery packs and is for reference
only.
and a rack-mounted UPS.
Issue 07 (2020-01-10)
Adjustable guide rails are optional. You are advised to use adjustable guide rails if the UPS is rack-
mounted. If a 2 U device is to be installed, use M6x16 screws to secure the adjustable guide rails. If a 3
U device is to be installed, use two floating nuts and M6x16 screws to secure the adjustable guide rails.
The floating nuts are delivered with the UPS.
(1) LCD
Figure 3-3 and Figure 3-4
Copyright © Huawei Technologies Co., Ltd.
(2) UPS
respectively show the cable routes for a tower-mounted UPS
(3) Battery pack
3 Installation
29