Martin Audio MLA User Manual page 414

MLA System
USER GUIDE
At this point you can connect power, network, audio and the inclinometer feed to the array. First connect the 12-way mains
break-out loom to the distro hanger. This is secured using a flying pin through the large eye bolt on the top of the loom. If your
array will be larger than 12 cabinets and you are going to be using a second 12-way breakout, attach the steel rope supplied with
the flying system to the second hole in the distro hanger with another flying pin. This will hang halfway down the array and will
support the second break-out loom using a small shackle to attach the eye bolt on the top of the connector box to the loop in
the end of the steel rope.
Now the mains Tourmate, U-Net, Audio and Inclinometer cables can be connected. Most MLA and MLA Compact partners loom
these cables together, see the chapter on cables for more details. The Tourmate connecter mates with the chassis connector on
the box at the top of the main break-out loom. You can then plug in the shortest 16A CeeForm connector labelled '1' to the top
cabinet;-
MLA System User Guide V2.1
414