8" (200mm) bass driver and a 1" (25mm) ferrofluid cooled HF driver on a 70 x 50 degree horn. The WM0.5 is a wedge monitor version of the W0.5, utilising the same drive units and horn. In its wedge configuration, the horn of the WM0.5 exhibits a 50 x 70 degree dispersion pattern to increase the listening window in the vertical plane.
4" (100mm) voice coils in an optimally tuned compact reflex enclosure. NOTE: Passive systems such as the W0.5, WM0.5, W1, W2 (in passive mode) and W3P may be used without a WX3A controller provided recommended amplifier power is not exceeded and care is taken to avoid amplifier clipping.
90dB if people are exposed for a long period. Never stand close to loudspeakers driven at high level. Tripod Mounting The W0.5, W1, W2 and W3 incorporate a pole mounting socket to facilitate mounting on tripod stands. When using stands, the following precautions are advised: Ensure that the stand will support the weight of the speaker by checking the stand manufacturers rating.
CONTENTS PRINT GUIDES The W0.5, WM0.5, W1, W2 and W3 are provided with threaded inserts to allow the suspension of a single enclosure. Never suspend one enclosure from another to form an array or cluster using these fittings. The W2 and W3 are provided with optional MAN flying points for array construction.
PRINT GUIDES SYSTEM CONFIGURATIONS The W0.5, WM0.5, W1, W2 and W3 may be used to cover the full-frequency range – either distributed singly or arrayed in multiples. The WX3A and DX1 controllers provide appropriate system-specific low frequency equalisation for full-frequency operation. Where additional low frequency output is required, a WS2A sub-bass system driven from a separate amplifier fed from the sub- bass output of the controller can be added.
Need help?
Do you have a question about the W0.5 and is the answer not in the manual?
Questions and answers