Overview - Martin Audio MLA User Manual

MLA System
USER GUIDE

Overview

Either double clicking or right clicking and selecting Open will bring up the overview option for the DD12 which shows all DD12s
in the project;-
This gives an overview of the state of all DD12's allowing comprehensive monitoring of the system.
The box at the top will show any names that have been assigned to the cabinets by right clicking and selecting rename (or
selecting and pressing F2 in the System Diagram;-
The gain fader allows gain adjustment from -40 to +15dB. Precise values can be entered by typing directly in the box below the
fader or values can be scrolled up or down using the up/down buttons. The increments that the up/down buttons will step is
determined in the Preferences section, by default it will be 0.25dB.
The mute button will mute the cabinet irrespective of the position of the gain fader and will turn red when active.
There is comprehensive metering available. The bargraph to the left of the fader shows input level up to the maximum before
input clip of +18dBu. The smaller meters to the right show the amplifier output levels for both the low frequency amplifier driving
the 12"driver and the high frequency amplifier driving the compression driver and show level prior to limit. If the levels reach
the yellow segment you have reached the limiter threshold. A red segment indicated 3dB of gain reduction in the limiter.
MLA System User Guide V2.1
306