Martin Audio MLA User Manual page 289

MLA System
USER GUIDE
This allows individual control of gain, phase, polarity and mute for each sub in the array. Most often used when creating cardioid
arrays with a third of the subs rear facing and requiring independent control of the rear facing subs to the front. The LED button
gives you the option to flash the LED of each sub to ensure that you are applying parameters to the correct cabinet. If at any
stage you wish to reset the parameters, perhaps immediately after device discovery where the subs may still be displaying values
from their previous use, you can click on the 'Reset Outputs' button;-
A warning window will appear;-
If you click on OK, all gain and delays will be restored to zero, any inverted outputs will be re-inverted and any muted outputs
will be un-muted.
Subs also have the facility to turn off any troublesome amplifiers by checking the 'Mute Output Stage' box;-
Then clicking the Mute button on any sub you wish to turn off.
As with other cabinets there is a noise gate which has the Threshold and Hold Time available for modification. The Default values
can be restored at any time by using the Restore Defaults button;-
Both MSX and DSX have default values as shown above of a threshold of -84dB, a Depth of 10dB and a hold time of 5000ms.
When you have finished setting output parameters you can close the output window with a further click on the SHOW OUTPUT
button. Any amplifiers that have been switched off will have the AMPS OFF indication above the temperature read-out;-
MLA System User Guide V2.1
289