Switching The Dp2K-S Series Projector On - Barco DP2K-S Series User And Installation Manual

9. Starting up
9.1

Switching the DP2K-S series projector ON

How to switch on?
1. Ensure that the DP2K-S series projector is installed onto a stable platform. See chapter "Positioning the DP2K-S series projector
at port window", page 20.
2. Ensure that the exhaust system is properly installed. See chapter "Installation of the exhaust system", page 23.
3. Ensure the projector is correctly connected to the mains power. See chapter "Connecting the projector with the power net", page
25.
4. Ensure that the lamp and lamp house are correctly installed. See chapter "Lamp House & Lamp replacement", page 77.
5. Ensure that the correct lens is installed for your application. See chapter "Lenses & Lens selection", page 27.
6. Check if a video source is connected to the projector. See chapter "Input & Communication", page 35.
7. Press the Power Switch to switch the projector ON. As a result the projector starts up and the communicator touch panel starts
its initialization procedure.
Note: The projector always boots up in the same mode (E.g. Standby or Sleep) as it was switched off. This procedure assumes
that the projector was switched off in standby mode (projector fully operational but lamp is off).
8. Wait until the status light of the projector lights up GREEN (not flashing).
9. Press the STANDBY button on the Local Keypad or use the Communicator to activate the lamp.
10.Press the DOWSER button on the Local Keypad or use the Communicator to open the dowser.
Image 9-1
How to awake the projector from Sleep mode?
1. Press the SLEEP button on the Local Keypad for three seconds or use the Communicator to put the projector in Standby mode.
As a result the projector starts booting and initializing all electronics. During the booting and initializing phase the backlight color
of the Sleep button is purple (transition phase). Once the projector is fully awake the backlight color of the Sleep button is green.
Note: When the projector is in Sleep mode only the backlight of the Sleep button lights up red. The backlight of all other buttons
of the Local Keypad remains off.
The backlight color of the Sleep button, Standby button, Dowser button and Test Pattern button must all light
up green to project the image of the applied source.
C
AUTION
jector.
When for any reason a restart of the projector is required, the content server should be restarted also.
54
:
See user's guide of the Communicator Touch Panel to operate and control the DP2K-S series pro-
DOWSER
R5977692 DP2K-S SERIES 10/12/2012