Starting Up; Switching On The B-Series Projector; Switching Off The B-Series Projector - Barco DP2K-19B Installation Manual

8. STARTING UP

About this chapter
This chapter contains the switch ON and switch OFF procedures of the B-series projector. These procedures enumerate all the
important points which have to be checked prior to switching ON the projector. This is to ensure a safe start up of the projector.
Overview
•

Switching ON the B-series projector

•

Switching OFF the B-series projector

8.1 Switching ON the B-series projector
How to switch on
1. Make sure that the B-series projector is installed upon a stable pedestal. See chapter "Positioning the B-series projector at port
window", page 17.
2. Make sure that the exhaust system is properly installed. See chapter "Installation of the exhaust system", page 19.
3. Make sure that the right lens is installed for your application. See chapter "Lens selection", page 47.
4. Make sure that the lamp and lamp house are correctly installed. See chapter "Lamp & Lamp House", page 27.
5. Make sure the projector is correctly connected to the power net. See chapter "Connecting the DPxK-19B/23B/P with the power
net", page 22.
6. Check if a video source is connected with the projector. See chapter "Input & communication", page 57.
7. Check if the communicator touch panel is installed. See chapter "Communicator Touch Panel", page 67.
8. Press the power switch to switch ON the projector. As a result the projector starts up in standby. So, the lamp is OFF and the
dowser closed. No internal pattern is selected. The communicator touch panel starts its initialization procedure.
- When '0' is visible, the projector is switched OFF.
- When '1' is visible, the projector is switched ON.
9. Press the STANDBY button on the local keypad or use the Communicator Touch Panel to activate the lamp.
10.Press the DOWSER button on the local keypad or use the Communicator Touch Panel to open the dowser. As a result the applied
source will be displayed.
C
AUTION
When for any reason a restart of the projector is required, the content server should be restarted also.
8.2 Switching OFF the B-series projector
How to switch OFF the B-series projector?
1. Press the standby button on the local keypad or use the Communicator Touch Panel to switch the projector from operation to
standby. As a result the lamp turns off but the fans remain turning to cool down the projector.
2. Let the projector cool down at least 5 minutes or until the speed of the fans decreases.
3. Switch OFF the projector with the power switch.
R5905067 DPXK-19B/23B/P 17/09/2012
:
See user's guide of the Communicator Touch Panel to operate and control the B-series projector.
8. Starting up
71